![]() From Charts, select vSphere CSI, and go to configuration. Once the CPI shows deployed, we can continue on to the vSphere CSI. We will be deploying the CPI chart first, followed by the CSI.Ĭlick on the vSphere CPI chart, and under configuration, enter in the vCenter name or IP, your datacenter, and credentials, then click Deploy. #INSTALL KUBERNETES CLUSTER ESXI HABR INSTALL#To install the vSphere CPI and CSI, click into the Explorer for the cluster and in the upper left, choose Apps & Marketplace from the drop down. Once our cluster reaches an Active state, the last step is to deploy the vSphere CSI App into the cluster. An Provisioning message will be shown in the Clusters view until all nodes are deployed, and kubernetes is configured and accessible on the new cluster.ĭepending on storage, this could take a couple minutes. Everything needed to run a Kubernetes cluster will be deployed into the nodes. This is required since we will be using vSphere as our cloud provider.Ĭlick CREATE to start the deployment! At this point, Rancher will instruct vSphere to deploy 4 VMs from the Ubuntu template, and will customize according to the node template properties. The only thing to change is to select the radio button External under In-Tree Cloud Provider. Under Kubernetes Options there’s the ability to change the kubernetes version, as well as change the network provider, however, I’m going to stick with the defaults. I’ve increased this count to 3, selected the same node template, and reversed my checkboxes so that only Worker is checked. Next, click Add Node Pool and input a name for the worker nodes, “tsmith-wkr”. Select the etcd and Control Plane checkboxes, and clear the worker check box. On the first node, input the name prefix – “tsmith-mgmt” – and select the node template previously created in the drop down list. I’m going to choose 1 management node and 3 worker nodes. #INSTALL KUBERNETES CLUSTER ESXI HABR HOW TO#Now give the cluster a name, in my case “tsmith-k8s” and choose how to divide up the cluster. Then, select vSphere under the Create a new Kubernetes cluster section. From the previous post we have successfully set up the ubuntu VM template, deployed Rancher, and set up the requirements to deploy our template from Rancher – it’s now time to deploy the first cluster! Creating the first clusterįrom the Rancher main page, click on Add Cluster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |